...to work with the CBRD 2.75" Cold Charge pipe - CBRD cannot promise fitment with other cold charge pipes- It relocated the intake in the driver's front fender- allowing a cold air feed that helps to lower IAT- and increase HP- it also avoids the...
...the cp-e™ Core Front Mount Intercooler for the Mitsubishi Lancer; both Evolution X and Ralliart models. With a bar-and-plate core measuring 20.00” x 13.00” x 4.00” this intercooler utilizes the stock mounting locations and charge pipes; meaning...
...It's a little shorter and much smoother than the stock one. We also were able to relocate the BOV return hose using the stock hose to make it all look a LOT better under the hood. We HATED the factory hose routing it just looked horrible. The...
...It's a little shorter and much smoother than the stock one. We also were able to relocate the BOV return hose using the stock hose to make it all look a LOT better under the hood. We HATED the factory hose routing it just looked horrible. The...
...Valve Cover Breather- EVO X Part # AGP-EVOX-BREATHER Instead of venting your oil vapors back into the intake system, reroute into one of our professionally constructed and fully tig welded breather systems. Using the same filtering media as our...
...bolt 21+ Horsepower on to your EVO X! The KN typhoon Air Intake system includes turbo air intake pipe, high flow air filter, hose clamps, heat shield and all necessary hardware to install. It also includes a full upper upper intercooler pipe. 2...
...Solution continues to push the limits of high performance aftermarket products with our 4ply Silicone Turbo Inlet Hose. This hose is designed to work with Forced Performance 3" turbos. Our silicone hose smooths the air entering the turbo which...
...boost control solenoid kits will not degrade rich fuel mixtures like most common boost control solenoids. This will significantly extend life and eliminate the chance of sticking from contamination. They are pressure-tested to an amazing 100...
...Aluminum Hot Pipe- EVO X Part # AGP-EVOX-HOTPIPE The hot side tube is 2.5" mandrel bent polished aluminum with no weld joints in either pipe. The front pipe has a mounting tab to attach to the factory core support. The two pipes are joined by a...
...This is the newest offering for the Evo X intake system from Buschur Racing. The kit will include everything pictured which is our BR Evo X Mass Air Pipe, Air filter kit mounting bracket. The mass air pipe is made of 304 mandrel bent S.S. and...
...This is the newest offering for the Evo X intake system from Buschur Racing. The kit will include everything pictured which is our BR Evo X Mass Air Pipe, Air filter kit mounting bracket. The mass air pipe is made of 304 mandrel bent S.S. and...
...lower intercooler pipe upgrade kit is a good mod to do after you have installed a cat-back exhaust, downpipe, and intake on your EVO 10. - Replaces both lower pipes from intercooler to throttle body - 2.5" Stainless Steel Piping - Bead Rolled...
...all new STM Evo X Intake Pipe Kit is tig-welded in-house of 3" lightweight aluminum and incorporates a 6" velocity stack to utilize the air space of the giant KN filter. We include an aluminum intake heat shield, STM silicone coupler, clamps,...
...The Hallman EVOLUTION RX Kit uses the same valve as the Pro RX Kit, and has the same features (INCLUDING A CERAMIC BALL), but ALSO is integrated into a self-contained cockpit controller cable system. It also includes a mounting bracket, 3 feet...