Agency Power is proud to be the first in the world to release a complete Garrett bolt on turbo upgrade for the new Mitsubishi EVO X. This turbo upgrade features all the hard parts you need to take your EVO X to the next level.

Ditch your stock Evo X wastegate actuator for a high pressure adjustable AGP billet aluminum unit.

This replaces the factory installed piece, and will allow you to hold higher boost pressures to redline.

Because the AGP Wasteg...

The Artisan performance Street Assassin 50 is the world’s first bolt on turbo upgrade for the new Evolution X.

The SA50 has been dyno proven to put down over 450whp on pump gas and propel a full weight EVO X to high 11 sec tim...

Instantly stabilizes boost pressure at high-rpm range!

Brand new Mitsubishi stock Evo X Turbocharger. This is a authentic genuine Mitsubishi part.

TECH TIP: This turbo is brand new from Mitsubishi and NOT a rebuild.

This unit features the 54lb/min 73mm HTA compressor wheel and a new 65mm revision of the high efficiency 67mm turbine wheel used in the FP Red™ for the perfect combination of power and rapid spool.

The EVO X Green also comes standard with out huge 3" inlet elbow and surge ported c...

This turbo can sustain well over 35psi of boost pressure and still keep turbine back pressure in check due to our proprietary advanced turbine aero and massive turbine blades.

Due to the advanced design of the blades the spool up is retained near that of the stock turbocharger. Th...

Tired of boost falling off in your EVO X?

The Forge Motorsports EVO X billet actuator will eliminate boost fading!

This actuator will hold a solid 35psi to 8500rpm on a 50trim turbo.

Comes equipped with a 15psi spring and will accept sto...

The new HKS actuator will eliminate boost fading. The HKS wastegate utilizes larger internal diaphragms than the original equipment actuators allowing quicker turbocharger spool up and boost stability.

GT3240 turbine rated up to 580HP eliminating the problem of boost and power drops in high rpm ranges.

Utilizes the stock exhaust manifold in conjunction with a heat resistant steel adapter to mount the turbine and the 50mm GT II external wastegate. This design assis...